EMT Practice Test

1. Question Content...

---

Question1: Relative humidity is

Question2: The primary difference between Non-Convertible vs. Convertible coatings is:

Question3: NACE SP 0178 is a standard for:

Question4: The form of corrosion that has the largest potential for unexpected catastrophic failure is:

Question5: Owners hire NACE Inspectors' with the expectation that:

Question6: If a Thermoset coating is heated it will:

Question7: ISO SA 3 is directly equivalent to:

Question8: You are the NACE Inspector on a 5000 sq. ft. job where SSPC PA 2 has been specified.
Assuming all areas are in compliance, how many gauge readings and spot measurements are required?

Question9: According to SSPC PA 2 a Spot Measurement is:

Question10: If the specifier does not identify a restriction level in accordance with SSPC PA 2, the default restriction level is:

Question11: Inspector's daily reports are used:
Select All That Apply

Question12: SSPC SP 1 identifies the use of:

Question13: What is the minimum spot measurement value allowed by SSPC-PA 2 in each 10 m2 (100 ft2) area?

Question14: What is used to determine compressed air cleanliness?

Question15: What is the minimum recommended distance away from an edge that an inspector should take a measurement with a dial-type magnetic pull-off Dry Film Thickness (DFT) gauge?

Question16: Check abrasive blast pressure with a

Question17: When using the ISO comparator in accordance with ISO 8503, if the surface profile does not directly compare to one of the four segments the inspector should:

Question18: Due to a previous premature coating failure the owner has required the original coating applicator to return to remove and replace 10,000 square feet of a failed three coat system at the applicator's cost. Due to the financial implications of another failure, the owner has offered you the job as the NACE CIP Level 1 Coating Inspector and explained that he expects you to be his "insurance policy" for this job. You have never been involved in a warranty job before and are unfamiliar with the coating system.
Your preferred FIRST course of action is to:

Question19: An Inspector should change position when:

Question20: You are the NACE Inspector on a tank lining project where a 50% solids epoxy tank lining is being applied. After application of the 19 coat you notice small blisters in some areas of the applied lining.
Your FIRST preferred course of action is to:

Question21: Which is a component that supplies most of the features and functions of the material?

Question22: ASTM Standards are applicable:

Question23: A successful coating inspector must be able to

Question24: Passivation can best be described as:

Question25: If the project specification DOES NOT state the specific DFT measurement standards, the inspector should use

Question26: ISO ST 3 is described as:

Question27: Common errors that can produce inaccurate readings when using Wet Film Thickness (WFT) gauges include:
Select All That Apply

Question28: Conventional spray is a good choice when:

Question29: The least effective method of surface cleaning is most likely

Question30: Inspection documentation is important because:

Question31: A NACE Coating Inspector is permitted to transport coating material when:

Question32: Stripe coats are generally applied to:

Question33: NACE Level 1 Inspectors have been trained to perform:

Question34: ISO SA 2.5 is defined as:

Question35: The initial steel condition is important to the NACE Inspector because: