EMT Practice Test

1. Question Content...

---

Question1: Daily reports are important because:
Select All That Apply

Question2: When applying Thermal Spray Coatings the specification is most likely to refence:

Question3: Stripe coats are best applied by:

Question4: Solvents are added to coating formulations to

Question5: Most industrial coatings are:

Question6: When using the ISO comparator in accordance with ISO 8503, if the surface profile does not directly compare to one of the four segments the inspector should:

Question7: The NACE Inspector should perform tests for soluble salts:

Question8: You are asked to be the only coating inspector on a small bridge recoating job where existing coating contains lead. The owners' representative has supplied you with the local code governing the removal and disposal of lead based coatings, however upon reading the document you having great deal of difficulty understanding the technical language.
As a NACE CIP Level 1 Inspector your preferred course of action is to:

Question9: An Inspector should change position when:

Question10: NACE SP 0178 is a standard for:

Question11: Osmotic blistering is most likely to occur as a result of

Question12: Inspector's daily reports are used:
Select All That Apply

Question13: ISO SA 3 is directly equivalent to:

Question14: Checking is

Question15: Check abrasive blast pressure with a

Question16: According to SSPC PA 2 a Spot Measurement is:

Question17: Safety Data Sheets must be carefully reviewed by:

Question18: If the project specification DOES NOT state the specific DFT measurement standards, the inspector should use

Question19: If the specifier does not identify a restriction level in accordance with SSPC PA 2, the default restriction level is:

Question20: Excessive working of the surface with a power grinder can be detrimental because excessive burnishing

Question21: You are an inspector on a project where SSPC SP 3 is specified.
What sort of tools should you expect the Contractor to use to achieve the standard?

Question22: Good records can provide maintenance departments with detailed information about ALL of the following EXCEPT

Question23: When working as a NACE Inspector in a situation where there is a difference of opinion, the Inspector needs to:

Question24: In a non-convertible coating the role of the primary solvent is to:

Question25: To achieve consistently accurate results with ALL alt test equipment

Question26: Whenever dissimilar metals must join, the most common practice is to

Question27: You are the NACE Inspector on a 5000 sq. ft. job where SSPC PA 2 has been specified.
Assuming all areas are in compliance, how many gauge readings and spot measurements are required?

Question28: Corrosion generally occurs at which of the following sites:

Question29: The most important factor resulting in improved job site safety is:

Question30: In the event of a conflict between the project specification and the coating manufactures' product data sheet, the Inspector's first course of action should be too:

Question31: An inspectors personal log book should contain:

Question32: If a Thermoset coating is heated it will:

Question33: When holiday testing is required the Inspector is always required to enforce NACE SP 0188:

Question34: Due to a previous premature coating failure the owner has required the original coating applicator to return to remove and replace 10,000 square feet of a failed three coat system at the applicator's cost. Due to the financial implications of another failure, the owner has offered you the job as the NACE CIP Level 1 Coating Inspector and explained that he expects you to be his "insurance policy" for this job. You have never been involved in a warranty job before and are unfamiliar with the coating system.
Your preferred FIRST course of action is to:

Question35: How many gauge readings does SSPC-PA 2 require within a 4 cm (1.5 inch) diameter circle?