EMT Practice Test

1. Question Content...

---

Question1: Which surface preparation method uses a dilute acid solution to remove laitance and I roughen the concrete surface?

Question2: It is always possible to see moisture on a steel substrate:

Question3: NACE Standards include:

Question4: Steel shot grit contaminated with oil or grease used in a cetrifugal blast cleaning should be

Question5: When working with someone who is very concerned about Stability and maintaining adherence to the status-quo, the Inspector should try to:

Question6: Corrosion is the reverse process of

Question7: WJ-1 is always performed using UHWJ at pressures above 210 MPa (30,000 PSI)

Question8: Surface preparation methods for Non-ferrous metals are:

Question9: Individuals conducting Coating Surveys should:

Question10: When measuring the Dry Film Thickness Of liquid coatings applied to galvanized ferrous substrates the most commonly used instrument is the:

Question11: The best choice of instrument for holiday testing of thick film concrete coatings is:

Question12: NACE Level 2 Inspectors have been authorized to perform:

Question13: You can use magnifiers to examine all of the following EXCEPT

Question14: Inspectors perform tests on linings that they may not perform on exterior coatings because

Question15: You are the NACE Level 2 Coating Inspector where SSPC PA 2 has been specified with an additional requirement that no individual gauge reading shall be below a certain value.
As this is not part of the standard you should:

Question16: You are the NACE Inspector on a project where a stationary floating structure is being coated and you notice a self-smoothing anti-fouling coating has been specified.
This is not a good choice because:

Question17: The cost of qualified Coating Inspection is normally offset by:

Question18: In which type of concrete are laitance commonly encountered?

Question19: You are the NACE Level 2 Inspector on a project where overcoating of galvanized steel is being performed. The specification references SSPC SP 16 as the surface preparation method. At the pre-job meeting operations personnel make it clear that abrasive blasting will not permitted. The Owner's representative asks you what other methods might be used.
Of the options shown below, what would be the preferred option in this situation?

Question20: Measuring methyl ethyl ketone (MEK) resistance of ethyl silicate inorganic zinc-rich primers by solvent rub requires

Question21: Pre-cleaning of work pieces will NOT remove

Question22: The HATE adhesion tester uses

Question23: NACE International Standards are developed by:

Question24: All of these are advantages of using repair patches EXCEPT

Question25: Which product, when closely inspected has a green or red layer of fusion bonded epoxy (FBE) that is visible directly on the steel?

Question26: From a corrosion perspective, the main difference between Ferrous and Non-Ferrous Metals is:

Question27: You are the new NACE Level 2 Inspector on a job which had been very problematic. The previous Inspector was fired duo to personality conflicts with the Contractor's supervisor. Upon arriving onsite the Contractor's supervisor advises you in no uncertain terms that you will be the next to go, unless you cooperate with him.
Your FIRST preferred course of action is to:

Question28: The solvent sensitivity/solvent wipe test (ASTM D4752) is used to determine the cure of

Question29: When performing testing in accordance with ASTM D 2583 the inspector may observe:

Question30: Eddy current DFT gauges are used to measure Dry Film Thickness in which of the following situations:

Question31: When a coating is expected to be exposed to temperatures above 93C (200 F) the best choice would be:

Question32: When NACE/SSPC WJ 1 is referenced; what type of equipment would the Inspector expect to see on the job:

Question33: Dehumidification is defined as the removal of moisture vapor from the air to

Question34: When performing inspection in accordance with ASTM D 4138 the Inspector will use: