EMT Practice Test

1. Question Content...

---

Question1: The __________
command can be used during an upgrade to verify that the upgraded SGMs have returned to UP status before upgrading other SGMs.

Question2: HealthCheck Point _____

Question3: What is a downlink interface used for?

Question4: When working with Maestro, what is the difference between using Clish and gClish?

Question5: On the MHO, to view connected ports and their functions, use the following command:

Question6: Where should sx_api_ports_dump.py command be ran?

Question7: Which command is used to set the number of sites in a Maestro environment?

Question8: What command can be run to show which SGM is selected to receive traffic?

Question9: Which command do you use to find bottlenecks in the system that are affecting performance, even functionality in some cases?

Question10: Which distribution mode assigns packets to an SGM based solely on the packet destination IP?

Question11: In case of Correction, where is information about Owner stored?

Question12: What is the purpose of RJ-45 connectors located at the front panel of the Orchestrator MHO-170?

Question13: What cannot be learned from the output of asg monitor command?

Question14: When security policy is installed

Question15: What is the purpose of g_tcpdump command?

Question16: Which licenses should be issued for the Orchestrator?

Question17: To display processes that are consuming excessive system resources, users should use the_____ command.

Question18: What is the Correction Layer mechanism?

Question19: What can be learned from the output of sx_api_ports_dump.py command?

Question20: Logs without a dedicated log file can be found in

Question21: Maestro allows running commands globally in Expert mode by using global prefixes, such as:

Question22: What happens if you apply a hotfix using gClish?

Question23: What command will be used for updating fwkern.conf file on all Appliances within Security Group?

Question24: Which blade configuration files should be backed up on the SG if upgrading from R80.30SP or earlier?

Question25: What does asg monitor command do?

Question26: What is the Orchestrator?

Question27: What kinds of transceivers are supported on Orchestrator MHO-140?

Question28: What Maestro component is automatically designated the SMO Master?

Question29: What happens when you make changes from Clish on the SMO Master?

Question30: In a dual MHO environment, MHO1 and MHO2 are connected to the SGM line cards in which way?

Question31: HealthCheck Point _____

Question32: The core four manual diagnostic tools include:
asg diag verify, asg perf -v, orch_stat -all, and

Question33: What is an uplink interface used for?

Question34: For the MHO-175, which ports are Management ports?

Question35: Multiple SGs can exist in a Dual Site environment. Each SG can be configured in one of three ways. Which is not one of those ways?

Question36: Layer 4 distribution is enabled by default in Maestro. Which is not a scenario when you would want to leave this enabled?