EMT Practice Test

1. Question Content...

---

Question1: Exhibit.

Refer to the exhibit, which contains a partial policy configuration.
Which setting must you configure to allow SSH?

Question2: Refer to the exhibit, which shows a network diagram.

Which protocol should you use to configure the FortiGate cluster?

Question3: Which, three conditions are required for two FortiGate devices to form an OSPF adjacency? (Choose three.)

Question4: After enabling IPS you receive feedback about traffic being dropped.
What could be the reason?

Question5: Exhibit.

Refer to the exhibit, which shows a partial web filter profile conjuration What can you cone udo from this configuration about access towww.facebook, com, which is categorized as Social Networking?

Question6: Exhibit.

Refer to the exhibit, which contains a partial VPN configuration.
What can you conclude from this configuration1?

Question7: Refer to the exhibit, which shows a custom signature.

Which two modifications must you apply to the configuration of this custom signature so that you can save it on FortiGate? (Choose two.)

Question8: Exhibit.

Refer to the exhibit, which contains a CLI script configuration on fortiManager. An administrator configured the CLI script on FortiManager rut the script tailed to apply any changes to the managed device after being executed.
What are two reasons why the script did not make any changes to the managed device? (Choose two)

Question9: Exhibit.

Refer to the exhibit, which contains the partial interface configuration of two FortiGate devices.
Which two conclusions can you draw from this con figuration? (Choose two)

Question10: Refer to the exhibit, which shows a network diagram.

Which IPsec phase 2 configuration should you impalement so that only one remote site is connected at any time?

Question11: Refer to the exhibit, which contains a partial BGP combination.

You want to configure a loopback as the OGP source.
Which two parameters must you set in the BGP configuration? (Choose two)

Question12: Exhibit.

Refer to the exhibit, which contains an active-active toad balancing scenario.
During the traffic flow the primary FortiGate forwards the SYN packet to the secondary FortiGate.
What is the destination MAC address or addresses when packets are forwarded from the primary FortiGate to the secondary FortiGate?

Question13: Exhibit.

Refer to the exhibit, which shows an ADVPN network.
The client behind Spoke-1 generates traffic to the device located behind Spoke-2.
Which first message floes the hub send to Spoke-110 bring up the dynamic tunnel?

Question14: Refer to the exhibit, which contains information about an IPsec VPN tunnel.

What two conclusions can you draw from the command output? (Choose two.)

Question15: Exhibit.

Refer to exhibit, which shows a central management configuration
Which server will FortiGate choose for web filler rating requests if 10.0.1.240 is experiencing an outage?

Question16: Which ADVPN configuration must be configured using a script on fortiManager, when using VPN Manager to manage fortiGate VPN tunnels?

Question17: Exhibit.

Refer to the exhibit, which provides information on BGP neighbors.
Which can you conclude from this command output?

Question18: You want to block access to the website ww.eicar.org using a custom IPS signature.
Which custom IPS signature should you configure?

Question19: Refer to the exhibit, which shows the output of a BGP summary.

What two conclusions can you draw from this BGP summary? (Choose two.)

Question20: Refer to the exhibits, which show the configurations of two address objects from the same FortiGate.

Why can you modify the Engineering address object, but not the Finance address object?

Question21: Refer to the exhibit, which shows two configured FortiGate devices and peering over FGSP.

The main link directly connects the two FortiGate devices and is configured using the set session-syn-dev <interface> command.
What is the primary reason to configure the main link?