EMT Practice Test

1. Question Content...

---

Question1: Which of the following methods is recommended for modifying the cell bandwidths across the entire network during gNodeB data reconfiguration?

Question2: Which of the following channels is not involved in NR random access of a UE?

Question3: Which of the following Information Is contained in a master Information block (MIB)?

Question4: Which of the following 5G technologies can be used to ensure the QoS and security of smart grid services?

Question5: Which of the following 5G network technologies can reduce IoV latency?

Question6: Which of the following X2 Interconnection solutions are supported by LTE and NR base stations?

Question7: As defined in 3GPP, the cell-specific reference signal (CRS) that is always sent in LTE cells is not used in NR, reducing Interference under light loads and control channel overhead.

Question8: Which of the following functions is provided by the network layer in the transport protocol stack?

Question9: In NSA networking, which of the following objects are unnecessary to configrued for a gNodeB in SI self-setup scenarios?

Question10: User performance testing can be used to collect Information regarding low Internet access rate for a user.
Which of the following information is not required to diagnose this issue?

Question11: How many OM channels does a gNodeB support at most?

Question12: In SA networking, incorrect TAC configurations will cause UE access to fail.

Question13: When a GPS divider is used, the maximum distance between the GPS antenna and the BBU is shortened.

Question14: Which of the following scenario using the GUI configuration mode in MAE- Deployment?

Question15: What is the typical output power of a 64T64R AAU?

Question16: In the contention-based random access procedure, which of the following is related to the time-frequency position of the PRACH used by the UE?

Question17: Which of the following boards is added, the base station Is reset and you need to log in to the LMT again?

Question18: What Is the maximum number of pRRUs on a CPRI link for RF combination?

Question19: Which of the following methods can be used to locate faults on the user-plane path?

Question20: If the dock of a base station is locked and the base station fails to obtain clock source signals, which of the following clock states is the base station in?