EMT Practice Test

1. Question Content...

---

Question1: A link from the branch SRX Series device chassis cluster to the Internet requires more bandwidth.
In this scenario, which command would you issue to begin provisioning a second link?

Question2: You are asked to change when your SRX high availability failover occurs. One network interface is considered more important than others in the high availability configuration. You want to prioritize failover based on the state of that interface.
Which configuration would accomplish this task?

Question3: Which process describes the implementation of screen options on an SRX Series device?

Question4: What are two fields that an SRX Series device examines to determine if a packet is associated with an existing flow? (Choose two.)

Question5: What is the correct ordering of Junos policy evaluation from first to last?

Question6: You are asked to support source NAT for an application that requires that its original source port not be changed.
Which configuration would satisfy the requirement?

Question7: Which interface is used exclusively to forward Ethernet-switching traffic between two chassis cluster nodes?

Question8: Click the Exhibit button.

Referring to the exhibit, which action will be taken for traffic coming from the untrust zone going to the trust zone?

Question9: You want to support reth LAG interfaces on a chassis cluster.
Which setting must be enabled on the interconnecting switch to accomplish this task?

Question10: What are the maximum number of redundancy groups that would be used on a chassis cluster?

Question11: Which SRX5400 component is responsible for performing first pass security policy inspection?

Question12: Click the Exhibit button.

Referring to the exhibit, which statement is true?

Question13: Click the Exhibit button.

A customer would like to monitor their VPN using dead peer detection.
Referring to the exhibit, for how many minutes was the peer down before the customer was notified?

Question14: You want to ensure that any certificates used in your IPsec implementation do not expire while in use by your SRX Series devices.
In this scenario, what must be enabled on your devices?

Question15: Click the Exhibit button.

You have configured NAT on your network so that Host A can communicate with Server B.
You want to ensure that Host C can initiate communication with Host A using Host A's reflexive address.
Referring to the exhibit, which parameter should you configure on the SRX Series device to satisfy this requirement?

Question16: Click the Exhibit button.

Referring to the exhibit, what will happen if client 172.16.128.50 tries to connect to destination
192.168.150.111 using HTTP?

Question17: Which statement is true about functional zones?

Question18: Which UDP port is used in Ipsec tunneling when NAT-T is in use?

Question19: Clients at a remote office are accessing a website that is against your company Internet policy. You change the action of the security policy that controls HTTP access from permit to deny on the remote office SRX Series device. After committing the policy change, you notice that new users cannot access the website but users that have existing sessions on the device still have access. You want to block all user sessions immediately.
Which change would you make on the SRX Series device to accomplish this task?

Question20: Click the exhibit button.

Referring to the exhibit, which statement is true?

Question21: Which type of VPN provides a secure method of transporting encrypted IP traffic?

Question22: Your internal webserver uses port 8088 for inbound connections. You want to allow external HTTP traffic to connect to the webserver.
Which two actions would accomplish this task? (Choose two.)

Question23: Which statement describes the function of screen options?

Question24: Click the Exhibit button.

You are configuring an OSPF session between two SRX Series devices. The session will not come up. Referring to the exhibit, which configuration change will solve this problem?

Question25: Which three elements does AH provide in an IPsec implementation? (Choose three.)

Question26: Click the exhibit button.

You are configuring security policies with Junos Space Security Director.
Referring to the exhibit, which two statements are true? (Choose two.)