MoreExam
1. Question Content...
EXPLANATION
Answer: X - EXPLANATION Content.
Question1: Refer to the exhibit.What is the purpose of eth2 on the CVMs?
Question2: An administrator is trying to correct high cluster IOPs and Cluster Controller Latency. Networking is the suspected issue.Which networking parameters should be configured in the Nutanix cluster?
Question3: An administrator is concerned that Prism will be inaccessible if Active Directory is unable to process logins.Which method should the administrator use to access the cluster in the event of this type of outage?
Question4: An administrator is planning to deploy a Nutanix cluster to support a few high-performance VMs. This deployment will have the following considerations:* Individual VMs will likely generate network throughputs in the range of 90-100Mbps* Due to the configuration of the VMs, it is unlikely that a node will host more than one or two of them at a time* Individual VMs will communicate with only a few (one or two) remote hosts at a time* Multicast will not be used in the environment* The hosts are connected via two 1GbE network connectionsHow should the administrator configure the network bonds to meet this requirement while maintaining the simplest switch configuration?
Question5: An administrator is implementing a VDI solution. The workload will be a series of persistent desktops in a dedicated storage container within a four-node cluster. Storage optimizations should be set on the dedicated storage container to give optimal performance including during a node failure event.Which storage optimizations should the administrator set to meet the requirements?
Question6: An organization is running a Nutanix Cluster based on AOS 5.10.x and VMware vSphere 6.7. Currently, the CVM network is segmented and Storage only nodes not present.A new security project based on NSX is coming. VMware Distributed Virtual Switches are required. The administrator needs to prepare the environment for the new project.Which step should the administrator use to initiate the project?
Question7: An administrator needs to create and start five new VMs for a Data Analytics Project (OLAP). The VM Profile is as follows:* vCPU:4* vRAM: 64 GB* vDisk: 1.5 TBEach of the four nodes of the Nutanix cluster has the following:* 24 vCPU. 20% overall usage* 192 GB RAM, 60% overall usage* 2xl920GBSSD* 4x 2 TB HDDAt cluster level, there is a single RF2 container that is 30% utilized and has an extent store capacity of 13.5 TB.Which component requires administrator attention?
Question8: Microsegmentation was recently enabled in a Nutanix environment. The administrator wants to leverage Prism Central to create a policy that will block all traffic, regardless of direction, between two groups of VMs identified by their category.Which policy should be used to meet this requirement?
Question9: An administrator needs to deploy an application with a large amount of data connected via Nutanix Volumes.Which two actions should the administrator take when designing the Volume Group? (Choose two.)
Question10: An administrator needs to evaluate if the existing configuration of Protection Domains meets the specified corporate recovery policy for SQL Data. The corporate policy requires that all SQL Servers be recoverable at the DR site within 30 minutes, and must result in a maximum of 60 minutes of data loss. SQL data must be required.The protection domain is configured as follows:* Application consistent snapshots are enabled* The SQL server VMs are assigned to the Protection Domain as their own Consistency Group* The Protection Domain schedule is configured as snapshots taken every 90 minutes from 7 am until 8 pm What must be changed to meet the required policy?
Question11: An administrator finds that home shares cannot be configured in a new Files 3.5 deployment. Why is this happening?
Question12: A VM does not have enough resources for the demand, which leads to performance bottlenecks. The VM is exhibiting one or more of following baseline values, based on the past 30 days:* CPU usage > 90% (moderate), 95% (high)* CPU ready time > 5%, 10%* Memory usage > 90%, 95%* Memory swap rate > 0 Kbps (no moderate value)Which type of VM is being described?
Question13: An administrator manages the following two Nutanix AOS 5.15 cluster environment:* Corp-cluster-01* Corp-cluster-02The VM images must be available only on Corp-cluster-01, but cannot be checked out to cluster Corp-cluster-02. The images also cannot be checked out to any other clusters that are registered with Prism Central in the future.Which two configuration settings must the administrator choose when creating the image placement policy that satisfies the stated requirements? (Choose two.)
Question14: An administrator recently added VLAN 205 CRM in Prism Element. The workloads attached to the associated NICs are unable to establish network connectivity.Which Layer 2 protocol allows the administrator to troubleshoot this issue from Prism Element?
Question15: An administrator protected a DB VM running on a Nutanix cluster with NearSync Replication, which schedules to repeat every 15 minutes to a second site. The daily change rate is low. During nightly backups, the replication window is missed due to write volume.Which two options describe the expected behavior? (Choose two.)
Question16: An administrator needs to expand a cluster based on AHV and running on Nutanix G5 hardware with a new Nutanix G7 system. The cluster is running AOS 5.10 but the operation fails when expanding the cluster. AOS is running on the new system. There are no issues discovering the node.Why is the operation failing?
Question17: A customer has a four-node cluster and is using Volume Groups to provide storage services to a SQL cluster.In the event of a CVM failure in the cluster, what is the expected IO path of the volume group's iSCSI targets?
Question18: Refer to the exhibit.An administrator logs in to Prism and sees the status shown in the exhibit within the Hardware Diagram section.What should the administrator do?
Question19: A customer needs a DR solution designed around the following requirements:* There are 8 ms of latency between Sites A and B* The administrator needs the shortest RPO/RTO possible* Application consistent snapshots are required* Use of Nutanix VSSWhich Data Protection Method should be used?
Question20: An administrator has a custom backup application that requires a 2TB disk and runs in Windows. Throughput is considerably lower than expected.The application was installed on a VM with the following configuration:* Four vCPUs with one core/vCPU* 4GB of Memory* One 50GB vDisk for the Windows installation* One 2TB vDisk for the applicationWhat is the recommended configuration change to improve throughput?
Question21: An administrator learns that some security settings in a cluster have been changed. The environment is out of compliance with required policies.Which function should be used to revert any settings that have changed from the defaults and prevent further violations?
Question22: An administrator needs to forecast infrastructure requirements for a new program and its associated applications. Prior to the projected start of the new program, all existing applications will be decommissioned.How should the administrator perform this task?
Question23: An administrator needs to migrate workloads from a Nutanix cluster running VMware ESXi to Nutanix AHV. The migration process needs to be completed in multiple VM groups and support roll back in case any problems are found during user acceptance testing.Which action should the administrator perform?
Question24: An administrator is deploying an application that requires maximum I/O throughput for scratch data. The administrator is concerned that the throughput requirement is greater than what can be provided by a single cluster node.What should the administrator do to meet this requirement?
Question25: An administrator is performing a set of routine checks and notes that Prism Central is running with 4 vCPUs and 21 GB RAM. The organizations environment is based on two Nutanix clusters with 170 VMs plus a Legacy vSphere infrastructure. No manual changes have been done on Prism Central VM.Which configuration justifies the current Prism Central configuration?
Question26: An administrator is responsible for the following Nutanix Enterprise Cloud environment:* A central datacenter with a 20-node cluster with 1.5PB of storage* Five remote sites each with a 4-node cluster with 200TB storageThe remote sites are connected to the datacenter via 1GB links with an average latency of 6 ms RTT. What is the minimum RPO the administrator can achieve for this environment?
Question27: An administrator is migrating 5MB shares from a third-party platform to Nutanix Files with the following characteristics:* Shares contain user profile directories* DFS-N will be usedHow should the administrator create target shares for this migration?
Question28: A customer has NearSync configured. When the administrator tries to restore a snapshot from 3 minutes ago, it is not available. The snapshots are happening at 15-minute intervals instead of at the 5-minute configured interval. When the protection domain was initially set up, the snapshots were happening at the expected5-minute interval.What should the customer do to enable the snapshots to happen at the expected interval?
Question29: Refer to the exhibit.A Nutanix host is connected as shown in the exhibit with br0-up set to active/backup. Physical Switch 1 experiences a power outage causing br0-up to failover to using eth2. The CVM and host become inaccessible. User VMs restart on other hosts in the cluster, which causes a disruption to those VMs.Which configuration issue likely caused this outage?
Question30: An administrator is deploying a new application to a Nutanix Enterprise Cloud. The application requires a security to prevent unauthorized access. The application also uses many non-standard ports that are unique to it. Security should not be changed for existing applications.What should the administrator do to meet these requirement?
Question31: A customer wants to run SAP HANA on a Nutanix cluster with the following characteristics:* AHV nodes* SAP HANA version 2* Production database filesWhich configuration should be recommended to the customer?
Question32: Refer to the exhibit.A Microsoft SQL 2016 deployment is shown in the exhibit. The administrator receives user reports that database queries take too long to return.Which optimization should be made to this configuration to improve performance?
Question33: An administrator is configuring software only. Data-at-Rest Encryption on their Nutanix cluster. They are planning to deploy a third-party key management server (KMS).Where should this server be hosted?
Question34: An administrator knows that the disks in a cluster are out of date and a new firmware is available. For security reasons, these clusters do not have access to the Internet.Which two steps must be completed to update the firmware? (Choose two.)
Question35: A systems administrator needs to add more VMs to their Nutanix cluster.Which two actions should the administrator perform to determine if the current cluster can accommodate the new VMs? (Choose two.)
Question36: An administrator inherits a new Nutanix environment and logs in to a CVM to check the network configuration. The configuration is as follows:Which action should the administrator take to improve network performance?
Question37: An administrator receives a notification that storage in a Nutanix cluster is unavailable. The cluster consists of five nodes and is configured with a Fault-Tolerance level of 1 (FT-1).Upon investigation, the administrator finds the following:* All AHV hosts are powered on and the CVMs are running* Nodes A, B, and C are connected to one top of rack switch* Nodes D and E are connected to a second top of rack switch* The cluster status command run on Node A shows that CVM services on nodes D and E are down Which issue is causing the storage outage?
